SPECIAL ORDER ONLY

Call #614.300.5454 or email : info@urbntimber.com to place a Custom Order for this product.

Please note, free shipping does not apply to this product.

Allow 2-3 weeks for shipping.

SnowWhite is a pre-blended, stand-alone epoxy that does not get mixed with FlowCast or UVPoxy, but is an independent blend.

Compared to adding pigments to a clear epoxy, using SnowWhite produces a much better vibrancy that is more evenly blended and more cost-effective than buying a clear epoxy and white pigments. By using pigments, you end up needing a lot to get close to the same rich effect of SnowWhite.

SnowWhite consists of fillers and extra white pigments suspended in epoxy resin which are blended thoroughly, allowing for a uniform and incredibly brilliant white finish. SnowWhite mixes easily and is non-toxic with low odor, making it a perfect solution if you are looking for a bright white color for your next project.

SnowWhite can be easily worked using the same tools you would use when woodworking. It can be sanded, shaped, drilled, tapped, machined, and routered and will remain tough and durable for life. It will adhere and create a very strong bond with the surface it’s applied to.

———

SnowWhite Product Information (https://www.ecopoxy.com/products/snowwhite/)

Mix Ratio

2:1 by volume (3.1 : 1 by weight)

Working Temperature

20-25ºC (68-77ºF)

Working Time

5 hours (in mold) depending on ambient temperature

Recommended Thickness per Layer

1/2" - 1.5" per Layer. Maximum recommended pour depth of 1.5”. Not recommended for pours less than ½” depth

Tacky to Touch

14 - 24 hours*

Set to Touch

24 Hours

Demold Time

48 hours

Cure Time

7 days depending on ambient temperature, humidity and thickness

Clean Up

Isopropyl/ denatured alcohol or soapy water

Storage Temperature

15 - 25º C (59 - 77º F) with tightly sealed lids.

* During this time, a second pour can be done without the need to abrade the surface. Additional preparation is required if more than 24 hours have elapsed from the time of mixing. Lightly sand the entire surface with 220 girt sandpaper until glossy finish has been removed. Remove all sanding dust and wipe down the entire surface with isopropyl or denatured alcohol to remove contaminants.

Note: Processing times mentioned here are based on 1.5" deep casting, they may vary depending on the temperature, humidity, and pour depth.